Xerox 180 - Manual (Page 104)

SYSTEM CONTROL TASKS
4-20 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Displaying a console log
To display a console log:
Step 1. You can select either a saved or the current console log
To select a saved console log, select the Saved Log button and the
log’s file name from the Saved Console Logs field. You can use the
scroll bars to display additional log names. Once you select a file
name, it appears in the Saved Log field.
You can enter a saved console log file name directly into the Saved
Log field.
Note: The logs that appear in the Saved Console Logs field
are determined by the Read File From field. The default
selection for this field is Hard Disk. This means that the logs
displayed are saved on the PC UI hard disk. To display logs
saved on a floppy disk, insert a floppy disk in the floppy drive and
select the Floppy button.
To select the current console log, select the Current Log button. This
is the default selection of the window.
Step 2. Select the Display header button to open the Display Console Log
window (see figure 4-15).
Figure 4-15. Display Console Log window
Step 3. The following options allow you to select the type of information that
appears in the displayed console log:
• Complete. If you select this button, the log display contains
error, warning, and command logs sent to the system controller,
including power on messages.
•
Condensed. If you select this button, the log display contains
error, warning, and command logs.
• Errors. If you select this button, the log display contains
messages indicating a condition that prevents printer operation.
•
Warnings. If you select this button, the log display contains
messages warning of pending problems, but does not indicate
that the printer has stopped.