Xerox 180 - Manual (Page 244)

FILE CONTROL TASKS
10-6 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Step 5. Enter the blocking factor.
Note: This option appears only when you are copying from
system disk to tape. It is the number of disk blocks packed into
one tape block.
Step 6. Enter the name to be given to the new file in the Output File ID field.
•
The format is file-name.file-type.
The file name can be up to six characters in length and can
consist of letters or numbers. Punctuation characters (such as
a comma) or spaces cannot be used in the name.
•
If you do not enter a name in this field, the new file name is the
same as the input file name.
Step 7. If you are copying files from tape to disk, select the Review check box
to display a confirmation window when a file of the same name
already exists on the system disk (see figure 10-6).
Figure 10-6. Confirmation window (Review option)
From the window, you can select one of the following options:
•
Yes to write over the file on the system disk
•
No to skip to the next file in the Copy task
• End Review to end the copy review request.
A confirmation window no longer appears if a file of the same name
already exists on the system disk.
Step 8. Select the Next header button if you want the next file on the tape or
disk to be displayed in the Input File ID field.