Xerox 180 - Manual (Page 28)

SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 180 LPS
1-12 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Fault List icon. Select this icon to display the Fault List screen.
Refer to the “Fault masking and the printer control console” section
of the “Problem solving tasks” chapter for additional information on
this screen.
Guarded Tools icon. This icon is reserved for the service
representative and operators who have completed Advanced
Customer Training (ACT).
Message area. This area is used as follows:
• Lines 1 and 2. These lines display the current status of the
printer, for example, READY.
•
Line 3. This line displays messages concerning masked
conditions, such as low dry ink. These messages are preceded
by an asterisk.
•
Line 4. This line displays messages that originate at the system
controller.
Icons area. The following icons appear in this area:
Hint icon. This icon appears when a masked faultMT038 or
condition exists in the printer. (Refer to the “Fault masking and the
printer control console” section of chapter 12, “Problem solving
tasks,” for additional information.) The icon also appears on the PC
UI.
Fault icon. This icon appears when a fault exists in the system that
stops the printer or prevents it from printing. The icon also appears
on the PC UI.
Guarded tools icon. This icon appears when a maintenance task
requiring a Customer Productivity Workshop (CPW) trained operator
must be done. If you have successfully completed CPW, either check
the PC UI for messages concerning the maintenance task or touch
the Guarded Tools icon to display the Guarded Tools screen. If you
are not a CPW trained operator, notify your lead operator or a CPW
trained operator at your site.
Attention light
An Attention light is mounted on top of the inverter feeder/stacker
module. (Refer to figure 1-5.) The Attention light can be enabled or
disabled (refer to chapter 4, “System control tasks,” for instructions).
When enabled, the light has three states:
•
Off. No printer problems exist that require your attention.
•
Steady light. A situation exists that needs your attention (such
as low dry ink condition).
• Flashing. The printer has stopped and your attention is
required immediately.
Registration transport levers
The heavy paper levers are used to optimize performance when
running heavy weight or oversized papers. Refer to the “Printing
problems” section in the “Problem solving tasks” chapter for more
information on these levers.