Xerox 180 - Manual (Page 298)

PROBLEM SOLVING TASKS
12-18 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Figure 12-25.Area 18
Note the following:
•
Sometimes the printer control console messages direct you to
discard the last sheet delivered to the stack following a jam in
area 18. Check for this message when clearing an area 18
paper jam.
• If your LPS has frequent jams in this area, you may need to
clean the Q1107A sensor. Refer to the “Cleaning the sensors
and the reflecting surfaces” section of the “Maintenance tasks”
chapter.
•
If your LPS is fitted with a Bypass Transport Module, you
should check for paper jams in areas 19 and 20 after clearing
an area 18 paper jam. To do so:
To clear a paper jam of an LPS with a Bypass Transport Module:
Step 1. Open the Bypass Transport Module door.