Xerox 180 - Manual (Page 249)

FILE CONTROL TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 10-11
Step 6. Select the Apply or Apply/Close header button to begin the Copy
task.
Note: You may also rewind or unload a tape by selecting the
appropriate option from the header auxiliary menu.
Copy Unlabeled Tapes task
through command line
To copy files from unlabeled tape to system disk, enter the following
command:
COPY {TAPE | CARTRIDGE | TD n}[EBCDIC | ASCII] [ disk-id] file-
id
Table 10-4 lists each parameter and its description.
Table 10-4. COPY command parameters and descriptions
Parameter Description
TAPE The file being input is from a open-reel tape.
CARTRIDGE The file is being input from an 1/2 inch cartridge tape.
TD n The file is being input from the specified tape device.
EBCDIC ASCII The recording format of the tape being input. If you do not
specify either EBCDIC or ASCII, EBCDIC is assumed.
disk-id Tells which disk (DP0:, DP1:, DP2:, or DP3:) to which the
file is to be written. Keying in this parameter is not
necessary unless you want the file to reside on a specific
system disk.
file-id Gives the name of the file to be written to a system disk,
using the following form:
file-name.file-type.