Xerox 180 - Manual (Page 24)

SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 180 LPS
1-8 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
High-capacity stacker bins
The Xerox DocuPrint 180 LPS contains up to four high-capacity
stacker (HCS) bins as part of the feeder/stacker modules (stacker
bins A, B, C and D). Figure 1-8 shows two HCS bins. Refer to the
section “Optional printer components” for more information on the
optional feeder/stacker modules.
Figure 1-8. HCS bins
Each HCS can hold 2500 sheets of 20 pound/75 gsm paper. The
paper can be stacked onto the bin platform, a container on top of the
bin platform, or a pallet without its container (for container sizes 11
by 17 inches or A3 only). The stacking capacity is approximately 100-
150 sheets less when stacking into a container.
It is also possible to select the level to which paper will be stacked in
the HCS. Refer to the “Status and print tasks” chapter for additional
information.
A stacking elevator maintains the paper at the proper level for
stacking and lowers the stack for unloading. There is an offset
mechanism that offsets printed sets toward the front or back of the
HCS bin. Each HCS bin has unlinked double doors to provide you
with easy, yet safe, access for unloading paper from the printer.