Tape drive does not become ready – Xerox 180 User Manual
Page 315
PROBLEM SOLVING TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
12-35
Tape drive does not become ready
To solve this problem:
Step 1.
Determine if the tape drive is online by pressing the Scroll button until
the message display shows the Status display.
Step 2.
If the tape drive is offline, follow the procedures listed in the “Place
the tape drive online” section of the “Offline printing tasks” chapter.
Step 3.
If the drive still does not become ready, the cartridge may be inserted
incorrectly. Remove the cartridge from the transport and insert it
again.
Step 4.
If there is an error code message in the message display, record the
error code, press the Unload switch (see figure 12-43), and try the
operation again.
Figure 12-43.Unload switch
Step 5.
If the drive still does not become ready, call for service. If there is an
error code message on the message display, record the code and
report it to the service representative.
Unload button