Xerox 180 - Manual (Page 25)

SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 180 LPS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 1-9
Each HCS bin has a control panel consisting of buttons and
indicators, as shown in figure 1-9.
Figure 1-9. HCS bin control panel
1 Ready to Unload indicator
2 Please Wait indicator
3 Bin Unload button
4 In Use indicator
Ready to Unload indicator. When this indicator is lit, you can
remove printed sheets from the stacker bin.
Please Wait indicator. When this indicator is lit, the elevator is in
motion. This indicator goes off when the platform reaches its
destination.
Bin Unload button. Pressing this button causes the bin elevator to
lower. If the bin is in use and part of a SELECT AUTO combination,
the printed pages begin stacking in the other stacker bin. If the bin is
not in use, there is no effect on printing operations.
In Use indicator. When this indicator is lit, the bin is selected to
receive the next printed sheet.
Inverter
The inverter is part of the inverter feeder/stacker module. (Refer to
figure 1-5.) It allows for proper collation of the print job. It also directs
printed output to the sample tray, when required.
Sample tray
The sample tray is located on top of the printer. (Refer to figure 1-5.)
It can hold up to 100 sheets of paper. Certain types of output (for
example, transparencies) and requested sample prints of system
files (for example, fonts or forms) or the print job in progress are sent
to the sample tray. The sample tray also receives waste sheets that
cannot be sent to the purge tray.
Purge tray
The purge tray is located on top of the last feeder/stacker module.
(Refer to figure 1-5.) Aborted sheets (for example, sheets cleared
after a paper jam) are sent to this tray. It can hold up to 100 sheets
of paper.