Xerox 180 - Manual (Page 313)

PROBLEM SOLVING TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 12-33
Tape does not unload
To solve this problem:
Step 1. If there is an error code message on the message display, record the
error code.
Step 2. Press the Unload button (see figure 12-40).
Figure 12-40. Unload buttons
Step 3. Try unloading the tape again.
Step 4. If the tape still does not unload, record the error code on the message
display, record the time, and call for service.
Unloading a cartridge after a power failure
To unload a cartridge after a power failure:
Step 1. Turn the tape drive on. (Refer to the “Emergency procedures”
section of the “Offline printing tasks” chapter.)
Step 2. Press the Unload button.
Tape winds completely out of cartridge
Call for service. If there is an error code message on the message
display, record the code and report it to the service representative.
Unload
button