Xerox 180 - Manual (Page 301)

PROBLEM SOLVING TASKS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 12-21
Figure 12-29.Unlatching the paper feeder assembly
Step 5. Remove and discard any partially fed paper. Ensure that:
• The paper supply is neatly stacked
•
The stack is not higher than the MAX line on the length guide
• The length guide is firmly touching the back edge of the stack.
• For the high-capacity feeder trays, also ensure the side guide is
firmly touching the side of the stack.
Note: You do not need to discard transparencies and other
stiff materials unless they are damaged.
Step 6. For the processor feeder trays, relatch the paper feeder assembly by
pressing the green dot until the assembly clicks into place (see figure
12-30).
Figure 12-30.Relatching the paper feeder assembly
Step 7. Slide the tray back into the printer until the tray latches and press the
Continue button to resume printing.
Step 8. Discard any pages sent to the sample tray, purge tray, or unused
stacker bin when the misfeed was detected.