Xerox 180 - Manual (Page 67)

PAPER FACTS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 3-7
Table 3-5. Paper stocks guide
Stock type Instructions for use
16 pound/60 gsm paper • Load paper with ream wrapper seam side down. If there is no arrow on the
ream wrapper, load paper in trays 3, 4, 5 and 6 only, with curl up.
•
Duplexing 16 lb. paper is not recommended.
•
Best performance can be expected from trays 3, 4, 5 and 6.
20 pound/80 gsm paper Load paper with ream wrapper seam down. If there is no arrow on the ream
wrapper, load paper in trays 3 and 4 only, with curl up.
65 pound card stock
110 pound/200 gsm paper
(index) Run from any tray.
20 pound or 80 gsm dual-
purpose
3-hole drilled
4-hole drilled
7-hole drilled • Load with holes to the RIGHT.
•
Use the Align task to avoid printing near the holes.
•
Fan paper thoroughly and check for loose paper plugs prior to loading
Non-tearing 3-hole • Load in trays 1 and 2 only.
•
Load with holes to the RIGHT.
•
DO NOT run two-sided (duplex) prints.
Non-tearing • Load in trays 1 and 2 only.
•
DO NOT run two-sided (duplex) prints.
Xerox carbonless paper • Load paper in trays 3, 4, 5 and 6 only.
•
Only Xerox carbonless paper is recommended for High speed Xerographic
equipment.
3-hole drilled, edge
reinforced dual-purpose • Use trays 1 and 2.
•
Load paper with holes to the right, reinforced side DOWN.
• In two-sided (duplex) printing, degraded print quality may occur near the
reinforcement.
•
Leave stock in wrapper until use to achieve maximum stock flatness.
•
Run with no more than 200 sheets in a tray.
1
Transparencies—
Oversized (8.5 by 14 inches,
0.5 inch white stripe/216 by
356 mm, 1 mm white strip) • Load with the white stripe to the RIGHT in trays 1 and 2 (“shiny” side UP for
best performance).
•
Simplex only.
Preprinted stock Certain types of ink or insufficient drying time may cause the ink to adhere to
various machine components and printed sheets. Allow at least 3 hours of drying
time before using preprinted stock.
CAUTION: Certain preprinted stocks lie unevenly in the feeder trays. If the right
side of the stack is higher than the left in trays 3, 4, 5 and 6 SEVERE hardware
damage can occur. Load the stock in trays 1 or 2 or load fewer sheets.
Transparencies—
Paper-backed,
high-speed,
removable stripe
•
High-speed paper-backed transparencies may be run from trays 1 and 2
with paper side DOWN.
• Run no more than 50 removable stripe transparencies at one time.
•
Load the transparencies on top of approximately 50 sheets of paper.