Xerox 180 User Manual
Page 65
PAPER FACTS
XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
3-5
1.
Refer to the Paper stocks guide (table 3-5) for additional information
2.
Optional 7 X 10 enablement kit allows 7 by 10 inches/178 by 254 mm paper size.
3.
Make sure that heavy weight paper levers (located in areas 2 and 4 of the printer) are in the appropriate
position for the weight of paper being used. Refer to the “Prints are skewed“ section of the “Problem solving
tasks“ chapter.
4.
Curl direction should be determined before loading paper into trays. Refer to the “Paper jams and paper curl”
section of chapter 12, “Problem solving tasks,” for additional information.
5.
Curl direction should be determined before loading paper into trays. Refer to the “Paper jams and paper curl”
section of chapter 12, “Problem solving tasks,” for additional information.
6.
Curl direction should be determined before loading paper into trays. Refer to the “Paper jams and paper curl”
section of chapter 12, “Problem solving tasks,” for additional information.
Table 3-3.
Trays 3, 4, 5 and 6 (or high capacity trays) performance guide
1
Paper
Superior performance
Good performance
Performance limits and
suggested alternatives
Size range
2
8 by 10 to 11.69 by 17 inches/
203 by 254 to 297 by 432 mm.
Includes:
•
11 by 14 inches
•
11 by 17 inches
•
B4 (250 by 353 mm)
•
A3 (297 by 420 mm)
Smaller or larger sizes cannot
be used.
Weight range
20 to 110 pounds/80 to 200
gsm
16 to 20 pounds/60 to 80 gsm
3
Weights outside the limits
shown are not recommended.
Capacity
Tray 3: 2600 sheets, 20 pound/
80 gsm paper
Tray 4: 2600 sheets, 20 pound/
80 gsm paper
For greater capacity, use the
Autoswitch feature.
Type or
condition
•
Xerographic paper in
good condition
•
Predrilled stock (fanned
thoroughly)
•
Slightly curled paper
4
•
Manual two-sided
(duplex) prints
•
High speed label stock
•
Excessively curled
paper
5
•
Curl direction should be
determined before
loading paper into tray.
6
•
DO NOT use mylar
reinforced paper in trays
3, 4, 5 or 6. Hardware
damage may result. Use
trays 1 or 2.