Xerox 180 - Manual (Page 262)

MAINTENANCE TASKS
11-6 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Step 5. Place the removed cap over the opening on the end of the full waste
container (see figure 11-7).
Figure 11-7. Placing the cap on the waste container
Step 6. Slide a new, empty, dry ink waste container into the printer until the
container stops (see figure 11-8).
Note: Do not remove the cap from the new container.
Figure 11-8. Inserting the new dry ink waste container
Step 7. Close the printer doors.
Note: If any dry ink gets on your hands, wash them with soap
and cold water. Heat sets the ink permanently. If any dry ink
gets on your clothes, brush them with a dry paper towel or a stiff-
bristled brush. If this does not remove the ink immediately,
launder with detergent and cold water. Dry cleaners should be
told that the spot is dry ink for a printer, so they will not use a
solvent that sets the stain.