Xerox 180 - Manual (Page 68)

PAPER FACTS
3-8 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
1. You can order a mylar reinforcement tray which allows a feeder tray to handle up to 500 sheets of this type of
stock. Contact your service representative for additional information.
Tab stock • Load into trays 1 and 2 with tabs to the LEFT.
• For best performance, print should be centered on the tab and should not
extend to either edge.
•
Use tab stock in perfectly flat condition. DO NOT use deformed, bent, or
damaged tabs.
9-inch cover stock
110 pound/200 gsm Load into any tray.
High-speed label stock
•
Load FACE UP.
•
DO NOT run two-sided (duplex) prints.
Letterhead • Load into trays with side 1 UP and top edge toward the front of the tray
(avoid placing the print in line with the feed belt in trays 1 and 2).
•
Avoid using freshly preprinted paper.
Manual two-sided (duplex)
prints • Load into trays with printed side DOWN and top edge toward the front of
the tray (avoid placing the print in line with the feed belt in trays 1 and 2).
•
Print the second side as soon as possible after the first side to prevent
wrinkling and excessive curl.
Textured paper Heavily textured paper may yield prints with ragged character appearance and/
or deletions. To test, print a sample sheet.
Table 3-5. Paper stocks guide (continued)
Stock type Instructions for use