Yamaha DME - Manual (Page 160)

Chapter 3 Main Panel Window
DME Designer Owner’s Manual 160
■ IP Address
Displays and sets the IP address of the DME or SP2060 unit connected to the port specified by
Port Select.
■ Master ID
If the DME or SP2060 unit connected to the port specified by Port Select is a slave device, the
fourth octet of the of the device group master IP address is displayed and can be edited here. This
parameter is display only if the device is the device group master.
■ Link Mode
Displays and sets the link mode of the DME or SP2060 unit connected to the port specified by Port
Select.
■ MAC Address
Displays the MAC address of the DME or SP2060 unit connected to the port specified by Port
Select.
NOTE
If the device group master IP address is changed and you are using the DME-N Network Driver, quit the DME Designer
and then restart it after changing the DME-N Network Driver settings.
NOTE
The subnet mask is fixed at “255.255.255.0”.
NOTE
Always use a local address (192.168.0.2. through 192.168.255.253) unless it is absolutely necessary to use a global
address. Consult with the network administrator if it is necessary to use a global address.
NOTE
Be sure to set the DME and SP2060 to a different device group.