Yamaha DME - Manual (Page 196)

Chapter 4 Designer
DME Designer Owner’s Manual 196
■ [Configuration Manager]
Displays the “Configuration Manager” dialog box. Here you can add, delete, or rename a
configuration.
→ See “Adding, Deleting, and Renaming a Configuration” on
page 281 .
■ [Save User Module]
This command can be used only when a User Module is selected in the Configuration window.
Saves a template for the selected user module.
→ “User Module Manager” Dialog Box in “User Modules” (
page 296 )
■ [User Module Manager]
Displays the “User Module Manager” dialog box. Changes the settings of, renames, or deletes a
user module saved as a template.
→ “User Module Manager” Dialog Box in “User Modules” (
page 300 )
■ [Show Signal Delay]
The digital signal delay value is displayed in the configuration window with sample units.
→ "Show Signal Delay (Delay Display Value)" in "Configuration Window" (
page 291 )
■ [Analyze]
Displays the “Analyze” dialog box, and analyzes the configuration.
→ "Analyze (Configuration Analysis)" in "Configuration Window" (
page 294 )
■ [Probe Monitor]
Turns the probe monitor ON or OFF. This command can be selected only when a Configuration
window or User Module window is active while in online status.
→ “Probe Monitor” in “Configuration Window” (
page 289 )
■ [Monitoring Point List]
Opens the “Monitoring Point List” dialog box. Registers points for monitoring with headphones.
→ "Monitoring Point List" in "Configuration Window" (
page 292 )
■ [Edit Mode]
Turns the edit mode ON or OFF.
→ “Edit Mode” in “Editing Configurations” (
page 180 )
■ [Sheet]
Opens the “Sheet Settings” dialog box. Sets the sheet size and background.
→ “Sheet” in “Objects” (
page 249 )
■ [Prohibit Diagonal Connections]
All connections will be drawn with horizontal and vertical wires only. Diagonal wires cannot be
drawn.
→ “Drawing Settings” in “Drawing and Editing Wires” (
page 269 )
■ [Grid]
Opens the “Grid” dialog box. Displays or hides the grid and sets the grid spacing.
→ “Grid” in “Design Window Shared Settings and Operations” (
page 257 )
NOTE
Only users for whom the [Operation Security] → [Edit] checkbox in the “Security” dialog box has been checked can
select this command.