Yamaha DME - Manual (Page 404)

Chapter 6 Component Guide
DME Designer Owner’s Manual 404
High Pass Filter (HPF)
The high pass filter passes frequencies in the signal that are higher than a specified frequency, while
attenuating lower frequencies in the signal. There are two types of HPF components: mono channel
and stereo channel. Mono channel HPFs have one input and one output. Stereo channel HPFs have
two of each.
Double-click a component to display the component editor for it. The parameters are the same for
mono channel and stereo channel components.
Section Parameter Setting Range Function
1
Input Level -
∞ to +10 dB
Sets the input signal level.
2 Phase ON/OFF Reverses the phase of the input signal.
3 HPF Frequency 20 Hz to 20 kHz Sets the cutoff frequency.
4
Slope 6 dB/Oct
12 dB/Oct Sets the attenuation for each octave.
5 Bypass ON/OFF Turns bypass ON.
6 Output Level - ∞ to ±0 dB Sets the output signal level.
2
1
5
3 4 6
HPF component editor