Yamaha DME - Manual (Page 270)

Chapter 4 Designer
DME Designer Owner’s Manual 270
■ Connecting Hotspots with Hotspots
Method 1 Clicking
Click the hotspot where the connection originates to begin drawing, then click the destination
hotspot. The two hotspots will be connected by a wire.
Method 2 Dragging
Drag from the origin hotspot to the destination hotspot.
■ Connect with Bent Line
Method 1 From Hotspot to Hotspot
Click the hotspot where the connection originates to begin drawing, then click the location (which
will become a node) where you want the line to bend. Finally, click the destination hotspot to
complete the connection.
Method 2 From Hotspot to Node or Line Segment
Click the hotspot where the connection originates to begin drawing, then click the location (node)
where you want the line to bend. Click an already drawn wire node or line segment to complete the
connection. If you connect to a line segment, a node will be created there.
NOTE
A termination cannot be connected to a terminal that will be shorted. Multiple connections cannot be made to a DME
object's Cascade port.
NOTE
When creating diagrams horizontally aligned hot spots can be automatically connected by pressing the <Shift> + < →>
keys or <Shift> + < ←> keys.
NOTE
A termination cannot be connected to a terminal that will be shorted. Multiple connections cannot be made to a DME
object's Cascade port.
NOTE
A termination cannot be connected to a terminal that will be shorted. Multiple connections cannot be made to a DME
object's Cascade port.