Yamaha DME - Manual (Page 445)

Chapter 6 Component Guide
DME Designer Owner’s Manual 445
■ Routing Settings
To change an assignment, click at the position where the desired input and output channels
intersect. When the mouse pointer is moved over a cell, the input and output channels are
highlighted, and a red line is displayed connecting them. Click to set routing for that position. If
another output channel has been assigned to the clicked input channel, the original assignment
will not be cleared. If another input channel has been assigned to the clicked output channel, the
original assignment will be cleared.
■ Clearing Routing Settings
If you click the dot that indicates routing, the routing indicated by that dot will be cleared and the
dot will be erased.
Click
Not Cleared Cleared
Click