Yamaha DME - Manual (Page 422)

Chapter 6 Component Guide
DME Designer Owner’s Manual 422
Output Channel Switching
The [Delay Matrix - All Inputs to One Output] editor window displays the output channel clicked on
in the delay matrix component editor. The [Channel] buttons in the [Output] section of the [Delay
Matrix - All Inputs to One Output] editor window switch the channel group that is displayed in the
window.
If you make the delay matrix component editor active while the [Delay Matrix - All Inputs to One
Output] editor window is displayed, and then click another output channel, that channel group will
be displayed in the [Delay Matrix - All Inputs to One Output] editor window.
One [Delay Matrix - All Inputs to One Output] editor window is displayed for each delay matrix
component editor.
■ One Input to All Outputs
When you click the input channel number on the left side of matrix, the [Delay Matrix - One Input to
All Outputs] editor window opens. One input channel and the send levels from the input channel to
all output buses are displayed. The input channel is the one you have clicked on in the delay mixer
component editor.
Section Parameter Setting Range Function
1 Input Channel -- Displays the selected input channel. Select another
channel from a menu.
2
Phase ON/OFF Reverses the phase of the input signal.
3 Level - ∞ to +10 dB Sets the input signal level.
4 Solo ON/OFF Turns solo ON. If Solo is engaged for even one
channel, all non-Solo channels will be muted.
5
On ON/OFF Turns input ON.
6 Bus Send Level Delay 0 to 500 ms Sets the delay time from the input channel to each
output bus.
7 Level - ∞ to +10 dB Sets the send levels from the input channel to each
output bus.
8
On ON/OFF Turns ON the send from the input channel to each
output bus.
9
)
!
@
1
2
4
5
3
6
7
8