Yamaha DME - Manual (Page 348)

Chapter 5 Components
DME Designer Owner’s Manual 348
Snap
The Snap function records parameters for the component editor, user control editor, and user module
editor temporarily. Clicking a button switches the parameter set, setting all parameters in the editor to
the status that existed when the parameters were recorded in the memory. You can record the current
values for parameters. Furthermore, when you recall a library, it is recorded to the Snap button that is
on at that time. For more information about libraries, see “Library” (
page 350 ).
■ Snap Buttons ([A] through [D])
The Snap buttons allow you to switch between parameter sets. The buttons change in appearance
according to their ON/OFF status and to whether or not there were changes to the parameter set
from when the editor was started.
When there has been no change to the parameter set since the editor was started
When a button is selected it lights up.
When a parameter set that is different than when the editor was started has been recorded
to a button
The color of the button name changes on buttons for which the parameter set has changed. When
a button is selected it lights up.
■ Recording Parameter Sets
Recording parameters from the current window
The parameters present when the snap button is switched are recorded to the snap button before
the switch.
1
Click the snap button ([A] through [D]) that will record the parameter set. This turns it
ON.
2
Set the parameters in the editor to the settings you want to record.
3
Click another snap button.
Snap Buttons
ON OFF
ON OFF