Yamaha DME - Manual (Page 274)

Chapter 4 Designer
DME Designer Owner’s Manual 274
■ Starting Drawing from the End Point/Node/Line Segment of an Existing Wire
You can draw from the end or midway point of an existing wire. If you start from a node or line
segment, a branch line will be created.
Method 1 Continue Drawing from a Wire End Point
When continuing an existing wire, right-click on the wire end point, then click [Continue Wire] on
the displayed context menu.
Method 2 Start Drawing from a Node
Right-click on a wire node, then click [Start Wire] on the displayed menu. You can start a branch
wire from the node you clicked on.
Method 3 Start Drawing from a Line Segment
Right-click on a wire line segment, then click [Start Wire] on the displayed menu. A node will be
created at the point you right-clicked, and you can start a branch wire from that node.
■ Drawing from Anywhere on the Sheet
Right-click the start position for drawing, the click [Start Wire] on the context menu that is
displayed. Click the location where the line should bend, then double-click at the end location to
finish drawing.