Yamaha DME - Manual (Page 76)

Chapter 3 Main Panel Window
DME Designer Owner’s Manual 76
“Event Log List” Dialog Box
Click the [Log List] button in the “Log Setup” dialog box to open the “Event Log List” dialog box. This
allows selection of the events to be stored in each DME unit. Events not selected here will not be
saved either in the DME unit or to a log file.
■ [Zone]
If you click here, a list will be displayed. Specifies a zone.
■ [DME]
If you click here, a list will be displayed. Specifies DMEs.
■ [Event]
Selects the events to be logged.
■ [Type]
Selects the event type for each event: [Information]/[Warning]/[Error].
■ [GPI OUT]
Specifies the port for event-triggered GPI output. If the same GPI port is specified for multiple
events GPI output will be produced when any of the specified events occurs.
■ [OK] Button
Applies any setting changes and closes the window.
■ [Cancel] Button
Closes the window without changing any settings.