Yamaha DME - Manual (Page 398)

Chapter 6 Component Guide
DME Designer Owner’s Manual 398
■ EQ Graph [Bypass] Button
A number for each frequency band is displayed on these buttons. When you click the button, it
lights up and the bypass turns ON. When you turn this ON, bypassed sound (unchanged sound) is
output. When you turn this OFF, the sound is output with effects applied.
Section Parameter Setting Range Function
4
Equalizer Bypass ON/OFF Bypasses each bands in the GEQ equalizer
section.
5 Gain Set by [Range]. Sets the output gain for its band.
6 GEQ ON ON/OFF Turns the GEQ ON.
7
Range ±15
±12
±6
-24 Selects the gain adjust width.
8 EQ Flat -- Returns the faders of all bands to 0dB.
9 Input Level - ∞ to +10 dB Sets the input signal level.
)
Phase ON/OFF Reverses the phase of the input signal.
! HPF Frequency 20 Hz to 20 kHz Sets the HPF cutoff frequency.
@ Bypass ON/OFF Turns bypass ON.
#
LPF Frequency 20 Hz to 20 kHz Sets the LPF cutoff frequency.
$ Bypass ON/OFF Turns bypass ON.
% Notch Frequency 20 Hz to 20 kHz Sets the notch filter frequency.
^
Q: 0.1 to 63.0 Sets the width of the frequency band that will
be changed by the filter.
& Bypass ON/OFF Turns bypass ON.
* Output Level - ∞ to ±0 dB Sets the signal level.
(
On ON/OFF Turns output ON.
Bypass ON Bypass OFF