Yamaha DME - Manual (Page 330)

Chapter 5 Components
DME Designer Owner’s Manual 330
Undo and Redo Commands During Editing
The [Undo] and [Redo] commands in the main panel window [Edit] menu, and the [Undo] and [Redo]
commands in the editing palette, can be used to undo or redo controller move, size change, or delete
operations.
Control Properties
A properties dialog box will open when you either double click a controller in the User Control Editor or
User Module Editor, or right-click the controller and select [Properties] from the contextual menu. Here
you can specify a design for the controller.
Multiple properties of the same type can be set at the same time by clicking the controllers while
holding the <Ctrl> key and then opening the properties dialog box.
Edited items are shown in bold text until you either click [OK] or [Cancel].
■ “Knob Properties” Dialog Box
When you right-click on a knob, then select [Properties] from the context menu, the “Knob
Properties” dialog box will be displayed. This dialog box sets the size of the knob.
[Size]
Displays a list where you can select the knob size. Select [Large], [Medium], [Small], or [Very
Small].
Color Settings
• [Indicator]
Select an indicator color from the list: [White]/[Red]/[Yellow]/[Green]/[Blue]/[Violet]/[Black]/
[Light Blue]
• [Thumb]
Select a knob color from the list: [Black]/[Gray]/[White]/[Red]/[Yellow]/[Green]/[Blue]/[Violet]
• [Background Color]
Uncheck this item to make the background transparent. When this item is checked the [Color]
button to its right opens the “Select color” dialog box that can be used to select a background
color.
NOTE
If you close an editor window, you will no longer be able to undo and redo operations performed there.
NOTE
You can change the size of a knob by dragging one of the marks at the four corners (top, bottom, left, right) of the knob
in the user control editor.