5200a configuration and monitoring, Front panel keys, Softkeys – YSI 5200A User Manual
Page 33
YSI 5200A
64
YSI 5200A
65
5200A Configuration and Monitoring
This chapter provides information on the 5200A’s front panel, navigating menus,
and menu functions.
The front panel - figure 4.1, is the front component of the 5200A enclosure. The
front panel contains the 5200A display and seven keys. Use the keys to navigate
menus and instrument system information.
This icon indicates helpful information for AquaManager users and is used through-
out this chapter. AquaManager provides access to 5200A system information from
a PC. Most 5200A configuration and monitoring can be done using AquaManager.
See Chapter 5 AquaManager - page 166.
Figure 4.1
Configuring the 5200A
Front Panel Keys
There are seven (7) 5200A front panel keys - figure 4.1. Use
▲
and
▼
keys to
scroll and highlight menu lists and to scroll through multiple Run Screens. Use
key to select and enter a highlighted submenu item and to hold one of multiple run
screens from scrolling. Hold is not an option when there is only one run screen.
Run screens can be scrolled when held by pressing
▲
and
▼
keys.
Notes:
Press and hold
-
▲
or
▼
longer than one second for continuous scroll-
ing.
Use
-
▲
and
▼
to scroll and view additional menu items when a scroll
bar appears to right of screen.
Pressing any of the four bottom keys resets any active alarm system. See
-
General Alarm - page 113.
Softkeys
Softkey labels appear on the bottom of the display and identify the function of the
softkey below them. Softkey labels change in different menus. Softkey labels and
their corresponding softkey functions are listed in table 4.1.
Note:
Not all menus and screens display four softkey labels. If there is no softkey
-
label, that softkey has no functionality.
Softkey label
Function
Access to Main Menu including:
calibration submenu
system submenu
sensor setup submenu
timers submenus
Display active-non timer control & alarm
system(s)
Access to Msg’s (Messages) Menu including:
sensor logs
event logs
calibration logs
Activate Service Hold
Configuring the 5200A