YSI 5200A - Manual (Page 53)

YSI 5200A
104 YSI 5200A
105
In the above sensor log screen shot ORP is disabled.
Event Logging
Menus → System → Data Logging → Event Logging
Control, Alarm, and Timer relays assigned to 5400 systems create events when they
turn on and off. In addition, AC power failures, ethernet device error messages,
and slave network failures are create events. These events are stored in the Event
Log. Event logs identify the 5200A system, are time and date stamped, and record
relay the action (“on” or “off”).
Enter Event Logging menu 1.
Menus → System → Data Logging → Event Logging
Use 2.
▲
and
▼
to scroll and highlight submenus.
Press 3.

to select.
Press 4. to turn off or on.
Press 5. to save configuration and return to Run Screen.
Press to view the 25 most recent event logs.
Press to view active (“on”) non timer events. See Control Menu - page158
for additional information.
Notes:
The General Alarm does not create an event log whether a general alarm -
relay is enabled or not.
- Events are not recorded when relays de-energize due to systemwide events.
Systemwide events include: calibration, Svr Hold, factory resets, power
cycle, 30 second sensor system reset, relay test, and disabling systems.
Event logs record the default system name and not the user configured -
system name.
Configuring the 5200A
Event logs do not record relay number or user configured relay name. -
Aux analog (non temperature) events will always display “alarm” regard- -
less if alarms are enabled, see below screen shot on left.
Aux digital events will never display “alarm” regardless if alarms are -
enabled, see below screen shot on right.
Clear Logs
Menus → System → Data Logging → Clear Logs
Use the Clear Log option to permanently delete all event and/or sensor log records
from the 5200A.
Before permanently deleting sensor and event logs, poll all data using AquaManager.
AquaManager will store all logs to a database in PC database.
Enter Clear Log menu 1.
Menus → System → Data Logging → Clear Logs
Use 2.
▲
and
▼
to scroll submenu.
Press 3.

to select.
The instrument will prompt, “Are You Sure?” Press one of the following 4.
softkeys to confirm: .
Selecting “Yes” automatically deletes logs and then returns to the Run 5.
Screen after approximately three seconds.
Selecting “No” or “Cancel” does not delete logs and returns to the Data 6.
Logging menu.
Configuring the 5200A