YSI 5200A - Manual (Page 98)

YSI 5200A
194 YSI 5200A
195
menu is configured.
System range (if applicable) are in - italics; “*” displayed after the range indi-
cates that the range is based on another system configuration i.e. set point
submenus.
(Not Available) indicates hardware is not installed. -
The following graphics are used in menu maps:
7 -
- Input is required at numeric or alpha/numeric keypad.
- - One of these softkey entries is required.
q - - Make a selection from a pull down menu.
- Use three front panel key to proceed; (only used at adjust contrast
menu).
The following menu map depicts how the menu map conventions and graphics are
used for configuring the pH alarm low value and enabling the pH alarm low relay.
Menu Maps
Appendix 3 - Menu Maps
This Appendix contains the menu structure for the 5200A. The menu maps contain
all submenus, factory defaults, and user selectable ranges of the 5200A firmware.
Menu maps are presented in hierarchal format. All menus are accessed by pressing
at the Run Screen. Menu maps are provided in the following order:
Calibration menu 1.
System menu 2.
Sensor Setup menu 3.
Timers menu 4.
The example below shows how to navigate the menu maps in this manual.
Find the menu you want to configure. For example, IP address for the 1.
serial to ethernet device.
Follow the path highlighted at the top of menu. Then, follow the path under 2.
and to the right of the menu heading to access the submenu.
Key strokes to enter IP address as depicted above.
From the Run Screen, press the softkey below 1. label.
Enter the System menu. 2.
Enter the Communication menu. 3.
Enter the Ethernet menu. 4.
Enter the IP Address menu - a numeric keypad is displayed. 5.
Configure the IP address using numeric keypad. 6.
Menu Map Key
The following conventions are used in menu maps:
Factory defaults are contained in ( ). - If blank, no default value is loaded for
this menu. In certain menus, the user configuration will appear in () once the
Menu Maps