IAI America ACON-CG - Manual (Page 21)

7
No. Task Note
7 Automatic
operation
z Before commencing automatic operation, make sure no one is inside the safety
fences.
z Before commencing automatic operation, make sure all related peripherals are
ready to operate in the auto mode and no abnormalities are displayed or indicated.
z Be sure to start automatic operation from outside the safety fences.
z If the product generated abnormal heat, smoke, odor or noise, stop the product
immediately and turn off the power switch. Failure to do so may result in fire or
product damage.
z If a power outage occurred, turn off the power switch. Otherwise, the product may
move suddenly when the power is restored, resulting in injury or product damage.
8 Maintenance/
inspection
z Whenever possible, work from outside the safety fences. If work must be
performed inside the safety fences, prepare “work rules” and make sure the
operator understands the procedures thoroughly.
z When working inside the safety fences, turn off the power switch, as a rule.
z When working inside the safety fences, the operator should carry a handy
emergency stop switch so that the operation can be stopped any time when an
abnormality occurs.
z When working inside the safety fences, appoint a safety watcher in addition to the
operator so that the operation can be stopped any time when an abnormality
occurs. The safety watcher must also make sure the switches are not operated
inadvertently by a third party.
z Put up a sign saying “WORK IN PROGRESS” in a conspicuous location.
z Use appropriate grease for the guides and ball screws by checking the operation
manual for each model.
z Do not perform a withstand voltage test. Conducting this test may result in product
damage.
z When releasing the brake of a vertically installed actuator, be careful not to pinch
your hand or damage the work part, etc., due to the slider dropping by its dead
weight.
* Safety fences --- Indicate the movement range if safety fences are not provided.
9 Modification z The customer must not modify or disassemble/assemble the product or use
maintenance parts not specified in the manual without first consulting IAI.
z Any damage or loss resulting from the above actions will be excluded from the
scope of warranty.
10 Disposal z When the product becomes no longer usable or necessary, dispose of it properly
as an industrial waste.
z When disposing of the product, do not throw it into fire. The product may explode
or generate toxic gases.