ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 36)

C HAPTER 1 M AINTENANCE T ESTS
30 9650-001356-01 Rev. D
14.0 SpO
2
Test (for SpO
2
feature without SpCO and SpMet)
Note: Perform this test if your unit has SpO
2
only. See the following procedure to test units
with SpO
2
, SpCO, and SpMet.
Equipment Fluke Index 2 SpO
2
Simulator (or equivalent), Masimo
®
Rainbow
®
SpO
2
finger probe
Test Setup Disconnect any ECG cable or IBP probes from the X Series unit.
Do This... Observe This... Pass/Fail
14.1 Power on the X Series unit without the SpO
2
sensor attached.
Verify that the SpO
2
numeric
displays INITIALIZING, then
goes blank.
14.2 Connect the SpO
2
sensor to the X Series unit. Verify that SpO
2
numeric
displays SEARCHING.
14.3 Set the simulator to 70% SpO
2
and 60 PPM.
Attach the SpO
2
sensor to the simulator.
Verify that after a brief period of
initialization, the
SpO
2
numeric
displays an SpO
2
value between
67% and 73%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
o o
o o
14.4 Set the simulator to 80% SpO
2
and 60 PPM. Verify that after a brief period of
initialization, the
SpO
2
numeric
displays an SpO
2
value between
77% and 83%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
o o
o o
14.5 Set the simulator to 90% SpO
2
and 60 PPM. Verify that after a brief period of
initialization, the
SpO
2
numeric
displays an SpO
2
value between
87% and 93%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
o o
o o
14.6 Disconnect the SpO
2
simulator.