ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 94)

C HAPTER 3 D ISASSEMBLY P ROCEDURES
88 9650-001356-01 Rev. D
Removing the Defibrillator Boards and Capacitor Bank
Modules
Tools Required
• #1 Phillips screwdriver with torque capability
• #2 Phillips screwdriver with torque capability
• 26 mm open end wrench
• Large diagonal cutters
• 5k Ohm, 25 watt, resistor
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
• Complete these procedures in the following order before performing this procedure:
1. “Removing the Handle” on page 63
2. “Removing the Printer Module” on page 64
3. “Disassembling the Main Unit” on page 66
To reinstall the defibrillator boards and/or capacitor bank modules, reverse
the steps.
Defibrillator Boards and Capacitor Bank Disassembly
1 Lay back end of separated
unit down with opened side
facing up.
2 Pull the black snap rivet
straight out.