ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 72)

C HAPTER 3 D ISASSEMBLY P ROCEDURES
66 9650-001356-01 Rev. D
Disassembling the Main Unit
Tool Required
• # 1 Phillips screwdriver with torque capability
• Wooden stick
• Kapton tape
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
• Complete these procedures in the following order before performing this procedure:
1. “Removing the Handle” on page 63
2. “Removing the Printer Module” on page 64
To reassemble the main unit, reverse the steps.
Main Unit Disassembly
1 Place tape on both sides of
the unit. (This will temporary
hold the sections of the unit
together).
2 Gently place unit screen so
the display is facing down.