ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 70)

C HAPTER 3 D ISASSEMBLY P ROCEDURES
64 9650-001356-01 Rev. D
Removing the Printer Module
Tools Required
• #1 Phillips screwdriver with torque capability
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
To reinstall the printer module, reverse the steps.
Printer Disassembly
1 Place the unit on the mat in a
horizontal position.
2 Open the printer housing and
remove the printer paper.
3 Place the unit screen down
and remove the three (3)
screws outside the printer
module in the illustrated
areas.
Note: During reassembly,
torque screws to 6 in-lbs.