Yokogawa Value Series FX1000 - Manual (Page 231)

10-6
IM 04L21B01-01EN
Communication Application Errors
•
Errors Related to E-mail and Web Server
260 IP address is not set or ethernet function is not available. The IP address is not specified.
Check the IP address.
See section 1.3 in the communication manual.
261 SMTP server is not found. Occurs when the SMTP server is specified by name.
• Check the DNS setting.
• Check the SMTP server name.
See sections 1.3 and 1.4 in the communication manual.
262 Cannot initiate E-mail transmission. • The host name of the FX is not correct. Check the host
name.
• The port number of the SMTP server is not correct.
Check the port number.
See sections 1.3 and 1.4 in the communication manual.
263 Sender’s address rejected by the server. Check the sender’s address.
Section 1.4 in the communication manual
264 Some recipients’ addresses are invalid. Check the recipients’ addresses.
See section 1.4 in the communication manual.
265 SMTP protocol error. May occur if a network failure (cable problems, duplicate
addresses, network device failure, and so on) occurs in
the middle of the e-mail transmission.
266 Ethernet cable is not connected. Check the cable connection.
See section 1.3 in the communication manual.
267 Could not connect to SMTP server. • Check to see that the SMTP server is connected to the
network.
• If the SMTP server name is specified using an IP
address, check to see that the IP address is correct.
See section 1.4 in the communication manual.
268 E-mail transmission request failed. Contact your nearest YOKOGAWA dealer.
269 E-mail transfer error. May occur if a network failure (cable problems, duplicate
addresses, network device failure, and so on) occurs in
the middle of the e-mail transmission.
270 Could not connect to POP3 server Check the connection settings.
See section 1.4 in the communication manual.
271 Not able to login to the POP3 server. Check the login name and the password.
See section 1.4 in the communication manual.
272 SMTP authentication failed. Make sure that the user name and password that you are
using for authentication are recognized by the server.
See section 1.4 in the communication manual.
273 The server requested an unsupported authentication
method.
Change the server configuration.
See section 1.4 in the communication manual.
275 The current image cannot be output to the Web. The setup display cannot be output to the Web browser.
This message is displayed on the Web browser.
276 Image data currently being created. Unable to perform key
operation.
Try again a little later. This message is displayed on the
Web browser.
277 Could not output screen to Web. Failed to create the image. This message is displayed on
the Web browser.
10.1 A List of Messages