GW Instek GDS-2000A series Programming Manual - Manual (Page 103)

COMMAND DETAILS
103
Measurement Commands
:MEASUrement:MEAS<X>:SOURCE<X> ..................103
:MEASUrement:MEAS<X>:TYPe ...............................104
:MEASUrement:MEAS<X>:STATE ............................104
:MEASUrement:MEAS<X>:VALue.............................105
:MEASUrement:MEAS<X>:MAXimum .....................106
:MEASUrement:MEAS<X>:MEAN ............................107
:MEASUrement:MEAS<X>:MINImum .....................107
:MEASUrement:MEAS<X>:STDdev ..........................108
:MEASUrement:STATIstics:MODe ...........................108
:MEASUrement:STATIstics:WEIghting .....................109
:MEASUrement:STATIstics .......................................109
:MEASUrement:MEAS<X>:SOURCE<X>
Description Sets or queries the measurement source for a
selected automatic measurement. This is a statistics
related command.
Syntax :MEASUrement:MEAS<X>:SOURCE<X> { CH1 | CH2 |
CH3 | CH4 | MATH | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15 | ? }
Related
commands :MEASUrement:MEAS<X>:TYPe
Parameter MEAS<X> The automatic measurement number
from 1 to 8.
SOURCE<X> SOURCE1: the source for all single
channel measurements.
SOURCE<X> SOURCE2: the source for all delay or
phase measurements.
CH1 to CH4 Channel 1, 2, 3, 4
MATH Math source
D0 to D15 Digital channel sources D0 to D15
Set
Query