GW Instek GDS-2000A series Programming Manual - Manual (Page 152)

GDS-2000A Programming Manual
152
Parameter/
Return parameter <string> The size of the string depends on the
data size setting. The string must be
enclosed in double quotes, “string”.
String contents:
x = don’t care
1 = binary 1
0 = binary 0
Example :TRIGger:BUS:B1:CAN:CONDition ID
:TRIGger:BUS:B1:CAN:IDentifier:MODe STANDARD
:TRIGger:BUS:B1:CAN:IDentifier:VALue
"01100X1X01X"
:TRIGger:BUS:B1:CAN:IDentifier:VALue?
>01100X1X01X
:TRIGger:BUS:B1:CAN:IDentifier:DIRection
Description Sets or queries the address bit as read, write or
don’t care.
Requirements: Firmware version V1.19 or later with
DS2-LA8 (or DS2-LA16).
Syntax :TRIGger:BUS:B1:CAN:IDentifier:DIRection
{READ|WRITE|NOCARE|?}
Parameter/
Return parameter READ Sets read as the data direction
WRITE Sets write as the data direction
NOCARE Sets either as the data direction
Example1 :TRIGger:BUS:B1:CAN:IDentifier:DIRection?
>WRITE
Example2 :TRIGger:BUS:B1:CAN:IDentifier:DIRection READ
:TRIGger:BUS:B1:CAN:IDentifier:DIRection?
> READ
Set
Query