2N Lift8 v1.0 - Manual (Page 120)

120
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Dragging Lifts between Groups Figure:
Lifts
Select a lift to open the most extensive third menu level including all relevant forms for
lift identification, check call evaluation and map position/installation site specification.
See below for details.
Basic
Use the Basic form to set the general lift parameters. The first row signals the lift
authorisation status, i.e. defines the 2N device type:
, or 2N
®
LiftNet 2N SingleTalk
®
or . Refer to the Adding Lifts paragraph above for details. The 2N Lift8
®
Unknown
next row includes Name and Password. The default password is 2n for the time being.
The Serial number is set to the telephone number when the lift is created by a call.
With CPC or P100, it is set to the value obtained by the device via the used protocol
during identification. Enter the IP address of the SIM card installed in the CU if
available into the IP address parameter to enable connection via TCP using the 2N
®
application. Set the phone number or CU identifying phone number 8 Service Tool Lift
for the
check calls: number of the CU SIM card, PSTN line to the CU, or 2N 8
®
Lift
PBX/gateway behind which the CU is installed. Enter brief information on the lift into
the Description parameter. Enter the address of the building where the CU is installed
into the Address field. This information will then be displayed on the map, which is
necessary for technicians' repair purposes or dispatchers' rescue team navigation.