2N Lift8 v1.0 - Manual (Page 57)

57
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.1 Programming the L8
The advantage of the is that it is programmed via the , where all the parameters L8 CU
are stored. For example, when changing an announcement it is not necessary to
reprogram anything. In the case of a system with several lifts you program only one
The memory is independent of the ’s power. CU. CU
Before you start programming
Use the prepared form, which is also a clear table of basic functions, and fill in all
the values you want to change.
If the
is not brand new, make sure that you have the correct servicing L8
password, and if you are not completely sure how the L8 is programmed, always
use full initialisation (NB! The servicing password is also initialised!).
L8 can be programmed in 3 ways. Remotely by telephone (using the telephone
number), using the machine room announcer, and or using the service tool
program (connection via USB or using IP address)
Make sure that your telephone allows tone dialling (there can be a problem with
so-called system telephones in some PBX).
Entry to programming mode
You can enter the programming mode during an incoming connection (calling number
L8) or using the machine room announcer (by pressing for longer than 2
seconds).
Using the voice menu you get through to programming (For administration press 9 ->
For entry to the programming menu press 1).
You are called upon to enter the servicing password in the format servicing password
(do not forget to put an asterisk after the password).
If the entered password is correct, L8 announces: “You have entered the
programming menu, select parameter”.
The factory setting of the password is 12345, and we recommend that you enter a
different password so that your equipment is protected from other people.
Caution
NOTA BENE! The servicing password is also initialised!