2N Lift8 v1.0 - Manual (Page 86)

86
2N TELEKOMUNIKACE a.s., www.2n.cz
®
5.2 Introduction to Application
In this subsection, we will show you the application menu layout and basic controls.
The application is divided into three menu levels. The first screen upon start includes
Configuration / Parameter/ Basic (see the figure below), which displays all of the three
menu levels. The horizontal Main menu (Configuration and Logs) helps you select
whether to configure the
system or supervise the history of logged events. 2N Lift8
®
The vertical menus (Parameters) help you select the area to be administered. The third
menu level, if meaningful, gets displayed horizontally in the right-hand upper corner
and includes a list of parameter setting forms.
Window Figure: 2N Lift8 Service Tool
®
The Main menu contains three pop-up menus. The Device menu helps you connect to
or disconnect from the CU. The Diagnostic pack menu helps you open a diagnostic pack
from a file on the disk and save it. Select the language mutation in the Language
menu: CZ and EN are available so far. You will always be warned before logout or
termination against data loss.
The Status line displays connection information. From the left: 'Connected to' includes
the name of the server to which you are currently connected, 'COM port' specifies your
PC COM port if you use a USB cable for connection, 'Current user' displays the currently
logged in user, 'FW version' specifies the current CU FW version and 'Serial number'
gives the CU serial number.
Note
The language change will not be executed until the application restart.