2N Lift8 v1.0 - Manual (Page 132)

132
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Call Server Menu
The Call Server is used for setting of the SIP lines via which the Central Units make
check calls. Enter the SIP line data to allow the line to register with its SIP Proxy
server. Make sure that the servers are set correctly. If you use a VoIP provider,
everything will work properly. If you have a SIP Proxy of your own, your LAN
administrator will communicate the correct settings to you.
Call Server Menu Figure:
The Call Server settings are located in the upper part of the menu. The first parameter
is the RTP port on which the server will send audio to the counterparty. The default
value is 5060. Some devices may require a server change. Typically, port 10000 and
higher are used so that the ports for common services cannot be interfered. The
Maximum line count parameter specifies how many SIP lines can be configured. When
this limit is reached, no more lines will be added and you will be notified by the
validator. The Maximum parallel call count gives the maximum count of check calls to
be processed at the same time. If more calls come to the server at an instant than the
server is able to process, the excessive calls will be rejected. The Call server state
parameter signals the current state of the server: Starting, Running, Waiting for
configuration and Error.
Caution
Set the SIP lines on the Therefore, you have to know 2N Lift8 Server!
®
the settings for the PC on which the server is installed. You need your PC
settings only if the server is running locally.