2N Lift8 v1.0 - Manual (Page 133)

133
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Click the first table row to add a SIP line. The row includes the 'Click to add a new item'
text. The table columns will get displayed and the row will be designated by the
validator. When all the necessary items have been set, the validator approves them
and the row is unchecked. The Save button is activated at the same time.
Non-validated parameters cannot be saved.
Enter the IP address on which the SIP Proxy is located in the Domain:Port column. The
parameter is optional. If you enter the SIP Proxy address only, port 5060 will be used
for registration. If you choose another port, enter the port number behind a colon.
Enter the Username for SIP Proxy authentication and the Password if the SIP Proxy
requires so. The Maximum DTMF timeout is set in seconds and the default value is 60.
If no DTMF dialling comes within this timeout after call answer, the call will be
terminated. The next column displays the current count of active calls via the given SIP
line and the Registration result shows the result of the SIP Proxy registration: the
registration packet will be resent in the event of failure. This parameter is updated
every 30 seconds. The last column helps you remove an existing row: click Remove to
remove a SIP line from the database.
Plans Menu
The Plans menu helps you administer plans of the buildings in which the lifts are
installed. Use the Lifts menu to assign these plans to the selected lifts and position the
lifts in the building plan. This information is then displayed to the 2N Lift8
®
operators. Communicator
Caution
If in a state other than the Call Server does not receive or Running,
process any check calls and all incoming calls are rejected.
Note
Enter and at least for a valid SIP line setting. Domain Username
Tip
Contact your LAN administrator or VoIP provider for the correct SIP line
settings.
Click Delete to remove the currently configured SIP line.
When registration fails, check the error code message in the registration
result parameter. If your registration data are correct, ask your LAN
administrator for help.