Logs, Logs - basic – 2N Lift8 v1.0 User Manual
Page 94
94
Figure: Left - Inactive Filter, Right - Active Filter
You can set the filter for each column separately as shown in the figure below. First
select the most convenient function to be applied to the string entered: Is equal, Is not
equal, Begins with, Ends with, Contains, Does not contain and many others. Enter the
text to be found into the Search string field and press Filter to activate the filter and
display the selected string in the column. Use another filter or another function to
make your search more precise. Remember to delete the set filters with the Delete
filter button in all the columns after filtering as the function settings are not cancelled
by server disconnection. When you logged in again without doing so, the filtration
results would get displayed to you instead of the entire set of data.
Filter Setting Result
Figure:
Logs
The Logs section helps you view the diagnostic messages recorded in the log files. No
logs are displayed upon the application start. Download the current logs from a file or
the Central Unit if connected.
Logs - Basic
The Basic menu includes a table with information rows. There are a few checkboxes
below the table for you to select which columns shall be displayed. You can display or
hide the timestamp, log level and log group. Click Refresh from device to enable the
autorefresh function and Download from device to read the current logs from the CU
connected. The table contains the following columns: Timestamp displays the log event
recording time and date, Level and Source specify the log type and source respectively,
and Message includes the log information. The State parameter above the table
specifies how many logs (rows) have been read and shows the log start/end time.