Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules - Manual (Page 184)

Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
192 Configure POINT I/O Modules in RSLogix 5000 Software
When you change entries for Data Format and Connection Type, note the
following:
• You do not delete the existing module.
• You do not create a new module.
• You bring forward configuration data for the new settings.
• Any configuration data you do not bring forward sets to the default value.
After you apply new settings for data format and connection, note the following:
• This is the base configuration for the next change in connection and data
format settings.
• You lose all configuration data from previous data formats.
The choices for connection type for modules depend on the communication type
format for the parent adapter, as explained in the user manual for the adapter.
Work with Dialogs for Analog Input Modules
Read this section for information about how to complete entries on the following
dialogs for analog input modules:
• Configuration
• Alarm Configuration
• Calibration
To display the dialogs, you typically click Configuration, Alarm Configuration,
or Calibration at the top of the General dialog.
Work with the Configuration Dialog
This dialog does not appear for Listen Only connections. To complete the entries
on this dialog, proceed as follows.
1. From the top of the General dialog, click Configuration.