Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules User Manual
Page 210
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
218 Configure POINT I/O Modules for DeviceNet Networks
4. From the Device Parameters dialog, at Groups select All parameters to
display each item and POINTBus to display only the run/idle command
and autobaud.
5. From the Device Parameters dialog, to monitor the output, click Start
Monitor, noting the following:
•
The output value is displayed for each scan.
•
Click All to scan all values.
•
The Start Monitor button turns to Stop Monitor during monitoring.
•
Click Stop Monitor to stop monitoring the selected parameters.
•
Identify monitoring by a ball appearing momentarily next to the
selected item during each scan.
Monitoring is identified
by the ball appearing
momentarily next to the
selected item during
each scan.