Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules - Manual (Page 214)

Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
222 Configure POINT I/O Modules for DeviceNet Networks
5. From the Device Parameters dialog, set Run or Idle, noting that any
parameter with a lock indicated next to it is nonchangeable..
6. Select values for current or voltage.
For current, click one of the following:
•
4…20 mA
• 0…20 mA
For voltage, click one of the following:
•
0…10V
• -10…+10V
Note that fault states include the following:
•
Hold Last state
• Go to Low Clamp
• Go to High Clamp