Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules - Manual (Page 195)

Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Configure POINT I/O Modules in RSLogix 5000 Software 203
If calibration fails, the Results dialog shows a failed calibration.
9. If calibration is successful, click Finish; otherwise, from the Results dialog,
click Retry to calibrate the channel that did not calibrate successfully and
repeat the process until calibration is successful.
10. Repeat calibration for each channel, if applicable.