Rockwell Automation 1734-XXXX POINT I/O Digital and Analog Modules and POINTBlock I/O Modules - Manual (Page 211)

Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Configure POINT I/O Modules for DeviceNet Networks 219
Configure Analog Modules
Using RSNetWorx Software Read this for a description of how to configure any analog module. The 1734-
IE2C and 1734-OE2C modules in this procedure are representative of input and
output analog modules. The actual dialogs for your particular module may not be
identical to the ones shown here. To configure analog input modules, proceed as
follows.
1. Open your RSNetWorx for DeviceNet software.
You see the RSNetWorx for DeviceNet dialog.
2. From the RSNetworx for DeviceNet dialog, use the selections in the
window on the left construct your system, or if your network is up, click
Browse.
3. Double-click the graphic for the desired module to display the General
dialog.
4. From the General dialog, click Device Parameters to see the dialog for
setting parameters.