Add distributed i/o to the i/o configuration – Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual User Manual
Page 133
Advertising
Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
133
I/O Modules
Chapter 8
•
DeviceNet
Figure 23 - ControlLogix System with Distributed I/O Example
Add Distributed I/O to the I/O Configuration
If you are adding distributed I/O, add the I/O modules to the communication
adapter of the I/O. To add distributed I/O to the I/O Configuration folder for
the ControlLogix controller, complete these steps.
1.
Add a communication module to the backplane that contains the
controller.
ControlLogix Controller Chassis
FLEX I/O
ControlNet
POINT I/O
EtherNet/IP
Advertising