Set the communication path, Go online with the controller – Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual User Manual
Page 58
Advertising
58
Rockwell Automation Publication 1756-UM001O-EN-P - October 2014
Chapter 3
Start Using the Controller
Allow the firmware upgrade to complete without interruption.
When the firmware upgrade is complete, the Who Active dialog box
opens.
Set the Communication Path
To go online with the controller, you must specify a communication path in the
Logix Designer application. You specify the communication path after you create
a controller program.
Complete these steps to specify the communication path after you have created
your program.
1.
Click Who Active.
2.
Expand the communication path and select the controller.
3.
Click Set Project Path.
Go Online with the Controller
Use one of these methods to go online with the controller:
Advertising