Rockwell Automation 1756-L6x_L7x ControlLogix System User Manual - Manual (Page 175)

Rockwell Automation Publication 1756-UM001O-EN-P - October 2014 175
Chapter
12
Redundant Systems
ControlLogix Redundancy
Overview Redundancy provides more system availability by switching control to a
secondary controller chassis if a fault occurs in the primary controller chassis.
The redundant system switches control from the primary to the secondary when
these faults occur:
• Power loss to primary chassis
• Hardware or firmware failure of any module in the primary chassis
• A major fault in the user program on the primary controller
• Loss of communication between the primary chassis and remote
ControlNet or EtherNet/IP modules
• Disconnection of an Ethernet patch cable from an EtherNet/IP
communication module in the primary chassis
• Removal or insertion of any module in the primary chassis
• A user command that causes a switchover
Topic Page
ControlLogix Redundancy Overview 175
System Requirements 177
System Considerations 178
Build a Redundant System 179
ControlNet Considerations in Redundant Systems 180
EtherNet/IP Considerations in Redundant Systems 180
Redundancy and Scan Time 181